Analysis and processing of common radio problems
1. can not power on or often power down?
Check whether the battery contacts are deformed or broken.
2. Walkie-talkie LCD display can not display or display incomplete?
Walkie-talkie worn or used improperly, caused by LCD broken or conductive rubber contact bad.
3.Do other group members conversation appear on your channel?
A.All radios in the group change another channel to communicate
B.Please change the CTCSS/DCS on all of the radios in the group, C.apply for a change frequency.
4. Does the radio have no sound at all?
A the volume switch broken, pull out the outshell of volume knob, switch by hand inside
5. Frequency interference
In the use of frequent frequency or received other radio noise, there are three ways:
A. Change the main frequency; b, Gaya audio; c, to improve the squelch level (under the same conditions, the emergence of individual machines applicable)
6. communication distance near
A.check if the antenna is in good condition, antenna seat is loose or damaged
B.change a high gain antennaB. whether set to low power, then change to high power
C. squelch level is set too high
D. If battery is low
E. If all above can not improve the communication distace, then apply to repeater to solve it
7. Receiving signal intermittent and accompanied by great noise?
May exceed the limit of communication distance of the walkie-talkie, or have big barriers, like tall buildings blocked in the basement and so on.
8. Can receive other radios speech but can not launch?
Check the PTT button is damaged, please try the headset with PTT key,if earpiece PTT key lauch normal, indicating that the radio PTT key is damaged.
9. Can not talk with other members of the group?
First make sure that the frequency and CTCSS/DCS you use are the same as the other members in the group. If there is no problem, please check if you and other members are within valid communication range
10. the other party receive a small voice?
A, check your radio MIC the hole is blocked
B, if volume of the end radio is rotating to the maximum
11. After programming a regular beep beep on the radio?
Intercom programming error. The frequency programmed is beyond the radio frequency rang, or the selected programming software model does not match the radio.
12. How long does it take for the battery to be used after normal charging?
If after charging, the battery always hold for a shot time.Battery life has come end, please replace the new battery. (Ni/Mh battery discharge durable for 500 times, lithium batteries 1000 times, the current market are generally using lithium batteries)
13. Do not scan the radio?
When the radio is programmed, the channel scan is not included (Professional settings) or the radio scan function is turned off.
14.Big Noise when switch the channels There’s no frequency in this channel, write the frequency in this channel is ok
At a distance of only a few meters between two radios, there’ll be whistle. This is a normal phenomenon,increase the communicate distance can resove
16. Can not read / write?
A.USB driver is not compatible with the computer system
B.the programming cable used is not brand correct cable
C.walkie-talkie and cable is not connecting good, pull out the cable and USB part,plug in firmly again
D.check if you are using the correct model programming software